![]() Set thermostat to “HIGH” before opening the feed est part of the fuel should be in the center of the fire box. DO NOT BURN OR USE GARBAGE, CHEMI- coal fuel only.ĬALS, GASOLINE, GASOLINE-TYPE LANTERN FUEL, KEROSENE, CHARCOAL LIGHTER COAL FUEL FLUID, DRAIN OIL OR OTHER FLAMMABLE Low ash content (2% to 6%) coal is recommended.OPERATING INSTRUCTIONS continued 1. The use of more than two 90° bends may decrease the amount of draft and possibly cause smoke spillage.OPERATING INSTRUCTIONS FUEL(S) DANGER: RISK OF FIRE OR EXPLOSION This furnace is designed to burn wood or 1. It is recommended that no more than two (2) 90° bends be used in the connector pipe instal- lation. If there is a clean out in the base of the chimney, close it tightly.ĬHIMNEY THIMBLE FLUE COLLAR 6˝ ROUND 24 ga.CONNECTOR PIPE INSTALLATION continued 6. ![]() As a means of exhausting smoke and flue gases that the chimney meets all of the UL rating requirements which are the result of fuel combustion.CHIMNEY CONNECTIONS continued The chimney used for a furnace must NOT be used to ventilate the cellar or basement. Tion and installation inspected before using. PLEASE SEE FIGURES 1 & 2 ON PAGE 6 AND LABELS AFFIXED TO APPLIANCE FOR PROPER CLEARANCES TO COMBUSTIBLE MATERIALS.ġ0 – Model 2500 Dimensions NORSEMAN™.CHIMNEY CONNECTIONS DRAFT When using a pre-existing chimney, have it’s condi- Chimneys perform two functions. 9 – Model 1500 Dimension NOTICE: THESE ARE PRODUCT DIMENSIONS ONLY. #Norseman Wood Heater Manual installSLIDE FIREBRICKS TOWARDS REAR SO NO GAPS REMAIN BETWEEN BRICKS.ASSEMBLY INSTRUCTIONS Yo u r N O R S E M A N ™ Wa r m A i r F u r n a c e requires the following items to be assembled or installed by the furnace installer: Feed Door Pull Handle/Thermostat Assembly Feed Door Locking Handle Blower(s) and Blower Control.FURNACE INSTALLATION NOTE: INSTALLATION MUST BE MADE BY A 6.įor parallel installations, install (two) 8˝ anti-back- QUALIFIED HEATING EQUIPMENT INSTALLER draft butterfly dampers (Vogelzang Model AD-8, not (one who is engaged in, and is responsible for, or is included with the furnace) in the heat (duct) pipes thoroughly familiar with the installation and operation a minimum of 18 inches above the furnace of gas, oil, and solid fuel burning heating appliances.NOTE: Do NOT break off jumper for low voltage. OTHER COMBUSTIBLE MATERI- ALS OUTSIDE OF CLEARANCE DIMENSIONS MARKED ON FURNACE. ![]() Listed UL C A U T I O N: F U R N A C E U N I T S A R E.LOCATING FURNACE continued WARNING: RISK OF FIRE DO NOT STORE FUEL, FLAM- MABLE LIQUIDS OR OTHER COMBUSTIBLE MATERIALS TOO CLOSE TO THE UNIT. Required, utilizing either a recently cleaned and inspected 6˝ masonry chimney or a 6˝ i.d. Install furnace pipe, elbows, and thimble as by a qualified heating equipment installer. This solid fuel furnace may be installed that it be fired as much as possible in order to reduce in conjunction with a central furnace that is in proper the demand on the central heating system.LOCATING FURNACE NOTICE: Installation of this furnace must be done 5. For the most efficient use of your is designed to provide supplemental or central heating NORSEMAN™ Warm Air Furnace, it is recommended for your home. 11 CHIMNEY CONNECTIONS.FURNACE DESCRIPTION & INSTALLATION OPTIONS Your NORSEMAN™ Solid Fuel Warm Air Furnace ate simultaneously. Dows and doors as needed to clear smoke and/or odor.TABLE OF CONTENTS SAFETY PRECAUTIONS.2 FURNACE DESCRIPTION & INSTALLATION OPTIONS.5 LOCATING THE FURNACE.Ħ TOOLS AND MATERIALS REQUIRED FOR INSTALLATION.7 ASSEMBLY INSTRUCTIONS.8 FURNACE INSTALLATION. Open win- HEATING AND COOLING CONTRACTOR ONLY. ![]() Persons with lung conditions NOTE: INSTALLATION SHOULD BE COM- or owners of susceptible domestic pets (such as PLETED BY A PROFESSIONAL, LICENSED birds) should take prudent precautions. (See specifics in Refer to instruction panels, caution and installation instructions).SAFETY INSTRUCTIONS continued and not occur again.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |